Huhu werte Com,
brauch jetzt mal wieder eure Hilfe. Von meinem ES 600 Sport sind heute die letzten Teile eingetroffen. Akku ist voll, in der Funke sind neue Batterien. Nun muss ich ja noch das Board mit der Funke "binden".
Andrew sagte, man solle den ON-Knopf am Board drücken bis das Antriebsrad entgegengesetzt des Uhrzeigersinns dreht. Danach nicht mehr drücken. Da fängts schon an. Kann da drücken wie ich will. Da dreht sich nichts!
Dann den Schalter am Griff anmachen und den kleinen Knopf unter der LED drücken. Was heißt den dort "half way"? auf halben Wege? 0.o
Jedenfalls rührt sich da noch nichts. Eine deutsche Anleitung wäre nicht schlecht. ^^
Hier mal die original Mail:
When your control box arrives you need to set it up. There is a small black button on the control box circuit board, with the board upside down and turned ON press it untill the drive wheel turns ANTICLOCKWISE then do not press it again.
Now resync your gun and control box by press ing another little black button under the white power button on the control box, you will need a small pin you should then get the power light flashing now turn your gun ON and press the little black button half way up the gun handle.
Oder hab ich da was falsch verstanden? Wenn ja bitte ich um Aufklärung. Meine Englisch Kenntnisse sind wohl nicht so gut. ^^
PS: Soll der Schalter oben auf dem Controller nur ein Taster sein? Dachte zuerst, dies sei der An/Ausschalter. Hab ich mich wohl geirrt.
MfG Meuras